Speaker endurance test
SPEAKER寿命实验
PURPOSE OF THE TEST实验目的:
The purpose of this test is to validate the lifetime of the speaker.
实验目的是为了验证移动电话Speaker的寿命。
Date
日期
Version
版本
Comments
备注
2006-8-1
1.0
New Creation
Function
职位
Name
姓名
Date
日期
Signature
签名
Written by
拟定
Quality Inspection Dept. Quality Technician
质检部质量技术员
熊小妹
2006-9-28
熊小妹
Verified by
审核
Quality Inspection Dept. Minister
质检部部长
刘泽燕
2006-9-28
刘泽燕
Approved by
批准
Deputy Quality Director
质量副总监
刘月利
2006-10-8
刘月利
1. General rules通用规则
See the following specifications:
"General rules for the performance of mechanical qualification tests" ref. TS–P–R–0080.
参考以下
:TS–P–R–0080“机械性能实验的通用规则”
Preparation of samples (see TS–P–R–0080):
The results of this test may be influenced by the presence of adhesive: NO.
The results of this test may be influenced by the presence of a coating: NO.
(coating = paint, varnish, metal finish, film in mold, film insert molding, stamped printing, pad printing, hot stamping, etc.).
样品的准备(见TS–P–R–0080):
此实验的结果可能受粘合剂的影响:否
此实验的结果可能受涂层的影响:否
(涂层包括:油漆、清漆、金属漆、模层、印刷层等。)
2. Principle 原则
This test is to set different mode to test under high temperature of 55±2℃, then inspect the ring in intermediate and final stage of the test..
实验过程是指移动电话在高温55±2℃条件下、设置不同的模式进行实验,然后在实验期间及最终检查响铃情况。
3. NUMBER OF SAMPLES样品数量
推荐的样品数量是15。
The recommended number of samples is 15pcs.
4. Equipment设备
The climatic chamber must have all the necessary specifications for applying the temperature profile to the samples.
恒温箱必须能够提供实验中所有需所要的温度条件给样机;
5. OPERATION METHOD操作方法
During the test, the handset is tested power on with SIM card and set mode as following:
∙ Under the 55±2℃ temperature condition, Set the samples continuously ring for long time, test time is 72 hours, inspect the ringing every 2 hours.
∙ Under the 55±2℃ temperature condition, Set samples continuously talking, ringing & vibration mode, and plug into charger, test time is 72 hours, inspect the ringing every 2 hours.
∙ Under the 55±2℃ temperature condition, Set samples continuously play MP3, test time is 72 hours, inspect the ringing every 2 hours.
∙ During the test, the ring volume must be the max.
实验期间,手机插SIM卡开机,并设置以下模式进行实验:
∙ 在55±2℃温度条件下,将样机设置成长时间不间断响铃模式,实验时间72小时,每2小时检查响铃情况;
∙ 在55±2℃温度条件下,将样机设置成通话、响铃+振动的不间断模式,手机插上充电器,实验时间72小时,每2小时检查响铃情况;
∙ 在55±2℃温度条件下,将样机长时间不间断播放MP3音乐,试验时间72小时,每2小时检查情况。
∙ 在实验过程中,响铃音量均调至最大。
6. CHECKS 检查
The samples are checked and any damage is rated in compliance with the specification “Checking handsets – NOK123 sanctions” ref. TS–P–R–0077.
样品检查和损伤的判定要符合规范TS–P–R–0077“检查手机——NOK123判定”。
Do not perform checking on network simulators.
不用在网络仿真器上进行检查。
7. REPORT报告
See the following specifications:
"General rules for the performance of mechanical qualification tests" ref. TS–P–R–0080.
"Checking handsets – NOK123 sanctions" ref. TS–P–R–0077.
参考以下规范:
TS–P–R–0080“机械性能实验的通用规则”
TS–P–R–0077“手机检查——NOK123判定”