音量模块vol3音量模块vol3
Channels:
Channel Function
1 while channel is on, ramps volume channels 1 and 2 up (increase) //1
ON 1,2路同时增加
2 while channel is on, ramps volume channels 1 and 2 down (decrease) //2
ON 1,2路同时减少
3 while channel is on, volume channels 1 and 2 are mute...
音量模块vol3
Channels:
Channel Function
1 while channel is on, ramps volume channels 1 and 2 up (increase) //1
ON 1,2路同时增加
2 while channel is on, ramps volume channels 1 and 2 down (decrease) //2
ON 1,2路同时减少
3 while channel is on, volume channels 1 and 2 are muted (lowest) //3
ON 1,2路同时静音,通道关闭后恢复之前水平
volume), and when channel is turned off volume levels
are restored to previous levels
4 while channel is on, ramps volume channel 1 up //4 ON 1路增加
5 while channel is on, ramps volume channel 1 down //5 ON 1路减少
6 while channel is on, volume channel 1 is muted (lowest //6 ON 1路静
音,通道关闭后恢复之前水平
volume), and when channel is turned off volume level
is restored
7 while channel is on, ramps volume channel 2 up //7 ON 2路增加
8 while channel is on, ramps volume channel 2 down //8 ON 2路增加
9 while channel is on, volume channel 2 is muted (lowest //9 ON 2路静
音,通道关闭后恢复之前水平
volume), and when channel is turned off volume level
is restored
10 while channel is on, ramps volume channel 3 up //10 ON 3路增加
11 while channel is on, ramps volume channel 3 down //11 ON 3路减少
12 while channel is on, volume channel 3 is muted (lowest //12 ON 3路
静音,通道关闭后恢复之前水平
volume), and when channel is turned off volume level
is restored
Note: Ramping a volume channel while the mute channel is on will //处在静
音的形式下是不恢复的
NOT automatically turn off the mute channel (will not restore)
but the ramping will still occur and the volume change
will be noticed when the mute channel is turned off. For
setting ramp rates and presets, see SEND_COMMAND programming
instructions for this card. For reading current volume levels
and displaying bargraphs see CREATE_LEVEL and SEND_LEVEL
programming instructions. Volume channels 1 through 3 use
levels 1 to 3 respectively.
Levels
1 = Output #1
2 = Output #2
3 = Output #3
SEND_COMMANDs:
'P